Auto High Mount LED 3rd Brake Light CHMSL Center Light for 2005-2015 Toyota Tacoma in Lebanon

Key Features of  Auto High Mount LED Third Brake CHMSL Center Light for 2005-2015 Toyota Tacoma : 

1. Third Brake CHMSL center Light offers superior brightness compared to traditional incandescent bulbs, improving visibility and safety on the road.
2. Featuring a sleek and modern design, this brake light adds a stylish touch to your Toyota Tacoma’s rear end, enhancing its overall appearance.
3. Designed as a direct replacement for the factory 3rd brake light, this LED brake light is easy to install with no modifications required. Simply remove the old brake light and plug in the new one.
4. Third Brake CHMSL Constructed from high-quality materials, including durable polycarbonate lenses and weather-resistant LED bulbs, this brake light  built to withstand the elements and maintain its appearance over time.
5. The bright LED bulbs provide instant illumination when you apply the brakes, alerting other drivers to your presence and reducing the risk of rear-end collisions.

Here are the steps to install the Spedking Auto High Mount LED 3rd Brake Light Brake CHMSL for 1995-2015 Toyota Tacoma :

  1- Ensure the vehicle is parked on a flat surface and the engine  turned off. Gather all the necessary tools for installation for more details visit our facebook page .

 2- Open the tailgate or trunk to access the area where the third brake light is located. In some vehicles, this may require removing an interior panel or accessing the light from inside the trunk.

3- Remove the Old Brake Light :

   – Carefully remove the screws or bolts holding the old third brake light in place using a screwdriver or socket wrench.

   – Disconnect the wiring harness connected to the old brake light by gently pulling it apart.

  4- Unbox the new Spedking Auto High Mount LED 3rd Brake Light and inspect it for any damage. Ensure all necessary components  included.

5- Install the New Third Brake CHMSL  :

   – Connect the wiring harness of the new LED brake light to the corresponding wiring harness in the vehicle. Ensure the connection is secure.

   – Position the new LED brake light in place of the old one, aligning it with the mounting holes on the vehicle’s body.

6- Secure the New Brake Light :

   – Secure the new LED brake light in place by tightening the screws or bolts. Ensure it  firmly attached to the vehicle’s body to prevent it from coming loose while driving.

  7 – Double-check all connections and mounting points to ensure everything is secure. Verify that the new  Third Brake CHMSL LED brake light is functioning properly and provides sufficient brightness.